Separate DMX addressing for each channel. Each channel can be programmed with the DMX address, a control curve, output-limit, preheat and the load check. Free programming of control curves.
• 12 internal memories can be recalled
as required, the memory can be activated
to fade-in, fade-out or to chase.
• The chase containing the internal memories
can be started.
• The chasing-speed, fadetime and the number
of steps (1-12) can be programmed.
• DMX-Off or DMX-Failure can start a chase
or call a memory.
• This dimmer can be completely locked while
the DMX or analog input works normally
as before.
• DMX and MIDI input.
• Master / Slave mode
• MIDI accepts "program change" signals
to call the internal memories, chase or "OFF".
Analog input works without any adjustment
Short circuit protection for each channel
with a 16 A circuit breaker.
• Simple and concise operation due to few,
clear menus.
• The LCD shows the input or output signals,
phase voltage, channel setting, memory, etc.
• Alarm of over-voltage and over-temperature
with switch-off.
• Electronic fuse and load-check
• Single phase connection: 10A/channel,
total 120A.
• 3 phase connection: 10A/channel,
total 40A per phase.
• Power requirement: AC 230V 50/60 Hz.
• Dimensions: 483 x 178 x 436 mm
(19 inch/ 4U)
• Weight: 31 kg
